Can be used with a majority of routers on the market.
The bar fits into one of the holes for the router side fence.
They have a pivot point whic...More Info
Can be used with a majority of routers on the market.
The bar fits into one of the the holes for the router side fence.
They have a pivot point ...More Info
The point attaches to one of the router fixed rods.
The pivot point is adjustable in height and this trammel can be used on most 8mm rods.
For 8 m...More Info
Designed to enable virtually any router to cut ellipses and circles.
Useds for corner tables, arches, desks and mirrors.
Setting-up and operating is...More Info
Threaded rods that extend the standard rods on the NCOMPASS/A allowing an increase in radius length of 440mm.
Two pairs of rods.
Rod 8mm diameter.
...More Info
This teardrop shaped base is fitted to the router and allows better control when edge moulding, by preventing router tilt.
Large knob for greater ...More Info
This router compass is used for cutting circles & arcs from 100mm up to 610mm radius.
Made of clear plastic.
Printed graduated scale for precise rad...More Info
Adjustable frame and guide for use with a router.
Adjustable frame for rectangles and squares.
Allows a router to cut recesses, slots, face panel...More Info
Pair of sliding friction clamps with 32mm clamping thickness.
The clamp can be used with the Varijig system including the varijig set, straight guide...More Info
Two lengths of extrusion with jointing piece to give a maximum working length of 100 inches (2540mm). Reduced length for easier transport and storage...More Info