For use in router tables where there is a limited router cutters shank length available.
Precision machined one-piece steel body.
With a 12mm sh...More Info
Multi-slit spring steel collet & nut set for the 1/2 inch or 12mm shank collet extension.
Will also fit the following machines:- Atlas Copco (AEG) ...More Info
Multi-slit spring steel collet & nut set for the collet extension.
Will also fit the following machines:- Atlas Copco (AEG) OFSE2000, Freud FT2000E...More Info
Multi-slit spring steel collet & nut set for the 1/2 inch or 12mm shank collet extension.
Will also fit the following machines:- Atlas Copco (AEG) ...More Info
Reduction sleeve is used to reduce the collet size to take cutters with smaller shanks. Should only be used as a stop-gap, as the the correct size co...More Info
Reduction sleeve is used to reduce the collet size to take cutters with smaller shanks. Should only be used as a stop-gap, as the the correct size co...More Info
Reduction sleeve is used to reduce the collet size to take cutters with smaller shanks. Should only be used as a stop-gap, as the the correct size co...More Info
Reduction sleeve is used to reduce the collet size to take cutters with smaller shanks. Should only be used as a stop-gap, as the the correct size co...More Info
Reduction sleeve is used to reduce the collet size to take cutters with smaller shanks. Should only be used as a stop-gap, as the the correct size co...More Info
Reduction sleeve is used to reduce the collet size to take cutters with smaller shanks. Should only be used as a stop-gap, as the the correct size co...More Info
Reduction sleeve is used to reduce the collet size to take cutters with smaller shanks. Should only be used as a stop-gap, as the the correct size co...More Info
Reduction sleeve is used to reduce the collet size to take cutters with smaller shanks. Should only be used as a stop-gap, as the the correct size co...More Info
Reduction sleeve is used to reduce the collet size to take cutters with smaller shanks. Should only be used as a stop-gap, as the the correct size co...More Info
Reduction sleeve is used to reduce the collet size to take cutters with smaller shanks. Should only be used as a stop-gap, as the the correct size co...More Info
Reduction sleeve is used to reduce the collet size to take cutters with smaller shanks. Should only be used as a stop-gap, as the the correct size co...More Info
Reduction sleeve is used to reduce the collet size to take cutters with smaller shanks. Should only be used as a stop-gap, as the the correct size co...More Info
One piece collet for the T3EK.
Does not include the collet nut.
Dimensions:
d=3 mm
Body length=20 mm
Body dia mouth.=12.2 mm
Body dia base.=...More Info
The collet is a one-piece multi-slit design to provide maximum grip on to the surface of the cutter's shank.
Does not include the collet nut.
D...More Info